Exterior Care - Trackmaster TMX58 Owner's Manual

TRACKMASTER
NOTE: The drive belt may stretch and loosen with regular use. This looseness may
result in a flapping noise under the hood.
1. Remove the (3) #10-32 screws located on the bottom hood with
wrench.
2. With the ¾" socket and wrench loosen the TENSION ADJUSTMENT back
nut.
3. Measure from the head of the ½"-13 bolt to the motor housing the spring
compression should be 1-3/16" or 30mm.
4. Using a ¾" wrench turn the TENSION BOLT clockwise to compress the
spring. To decrease compression, turn the wrench counter clockwise.
5. When the spring is compressed to 1-3/16" or 30mm, tighten the TENSION
ADJUSTMENT back nut.
NOTE: Failure to lock the TENSION ADJUSTMENT back nut will allow the drive
belt tension to become loose.
6. When the treadmill is properly adjusted, reinstall the hood with (3) #8-32
screws.
TENSION BOLT
1-3/16" OR 30mm SPRING
COMPRESSION

Exterior Care

The powder-coat finish on your TRACKMASTER
finish and requires minimal care. Do not allow perspiration to build up on
your treadmill. Wipe the unit daily.
August 2013 TMX58 Owner's Manual
Preventive Maintenance
1
/ " Allen
8
TENSION
ADJUSTMENT
Back Nub
®
is an extremely durable
7-5