Troubleshooting - CanyCom CG431 Operator's Manual

Troubleshooting

• If any malfunction or abnormal condition is found, immediately stop using the
machine and take an appropriate measure according to the Troubleshooting chart
below. If the malfunction or abnormal condition is not listed in the chart, or the
suggested measure does not solve the problem, consult with your CANYCOM
representative.
• Some corrective measures listed below require special knowledge and/or
equipment. Please contact your CANYCOM representative in such a case.
Area
Cutting rotor does not
run.
Cutting rotor does not
run.
Cutting
System
Cutting rotor vibrates
excessively when it is
run.
Troubleshooting
Malfunction
Belt is not properly
adjusted.
Belt is severed.
Faulty hydraulic
system.
Other (other than the
above).
Broken flail(s).
Foreign object is
tangled.
Other (other than the
above).
Possible Cause
→Adjust.
→Change.
→Refer to "Hydraulic
→Follow the
→Replace.
→Untangle.
→Please contact
-27-
Corrective Measure
Systems."
instructions in
"Working" to operate
the machine. If
problem persists,
please contact
your CANYCOM
representative.
your CANYCOM
representative.
6
Ref.
Page 8
Page 19