Installing the spark plug
Fit the spark plug by hand and
N
screw it in
Tighten spark plug with combination
N
wrench
Press the spark plug boot firmly
N
onto the spark plug
Position the cap for the spark plug
N
boot and screw it down
TS 410, TS 420
Rewind Starter
To help prolong the wear life of the
starter rope, observe the following
points:
Pull the starter rope only in the
N
direction specified.
Do not pull the rope over the edge of
N
the guide bushing.
Do not pull out the rope more than
N
specified.
Do not allow the starter grip to snap
N
back, guide it back into the housing
slowly – see chapter on "Starting /
Stopping the Engine."
Have a damaged starter rope replaced
by your dealer before it breaks
completely. STIHL recommends that
you have servicing and repair work
carried out exclusively by an authorized
STIHL servicing dealer.
Replacing the V-belt
2
1
1
1
Undo the nuts (1)
N
Turn the tensioning nut (2)
N
counterclockwise with the
combination wrench –
approx. 1/4 turn, as far as it will
go = 0
4
3
Pull the water hose out of the guide
N
in the V-belt guard
Remove screw (3)
N
Raise the V-belt guard (4) slightly
N
and pull it off to the front
Remove the V-belt from the front
N
pulley
English
0
33