Adjusting The Carburetor - Stihl TS 410 Instruction Manual

English
Replacing the air filter
Only if there is a noticeable loss of
engine power
4
3
2
1
1
1
Choke lever to c
N
Undo the screws (1).
N
Remove the filter cover (2) and
N
clean it
Remove the main filter (3)
N
Remove the auxiliary filter (4) –
N
ensuring that dirt does not enter the
intake area
Clean the filter area
N
insert new auxiliary filter and new
N
main filter
Refit the filter cover
N
Tighten down the screws
N
30
Only high-quality air filters should be
used, to protect the engine against
ingress of abrasive dust.
STIHL recommends the use of genuine
STIHL air filters. The high quality of
these parts will ensure troublefree
operation, a long service life for the
engine and extremely long filter life.

Adjusting the Carburetor

Basic information
The ignition system of this cut-off
machine is equipped with an electronic
maximum speed limiter. The maximum
speed cannot be increased beyond a
specified limit.
The carburetor comes from the factory
with a standard setting.
The carburetor has been adjusted for
optimum performance and fuel
efficiency in all operating states.
Preparing the machine
Switch off the engine
N
Check the air filter – clean or replace
N
it if necessary
Check the spark arresting screen in
N
the muffler (present only in some
countries) – clean or replace it if
necessary
TS 410, TS 420