Stihl TS 410 Instruction Manual page 23

2
2
2
6
5
6
6
Fit the "starter cover with rewind
N
starter" (5) over the studs (2)
Tighten up the nuts (6) by hand
N
7
8
Push the V-belt guard (7) into place
N
Screw in the bolt (8) and tighten up
N
Connect water connection
3
1
2
1
Insert the longer banjo bolt (1)
N
through the connector (2) of the
water attachment – observe the
position of the connector
Insert the square nut into the guide
N
in the guard and hold it in place
TS 410, TS 420
Fit the support with the longer banjo
N
bolt on the adjusting lever (3) –
screw in the banjo bolt and tighten
with the combination wrench
Insert the water hose into the guide
N
in the V-belt guard (arrow) from the
shut-off cock towards the guard –
avoid tight radiuses
Checking the adjustment range of the
guard
Rotate the guard forwards and
N
backwards as far as possible –
adjustment range (A) must be
limited by the stop pin
Continue as described in the chapter
"Tensioning the V-belt".
Inboard mounting
Disassemble the cutting wheel (see
N
"Fitting / replacing an cutting wheel")
Remove water attachment
N
Remove the adjusting lever
N
Slacken the V-belt
N
Remove the V-belt guard
N
Remove the "cast arm with guard"
N
Preparing the "cast arm with guard" for
inboard mounting
A
1 2
Unscrew the screw (1) of the limit
N
stop (2)
Remove the limit stop (2)
N
1 2
Turn the "cast arm with guard" so
N
that the guard is on the inboard side
Insert limit stop (2) – align the hole
N
in the limit stop with the hole in the
cast arm
English
3
21