Assembling The Cast Arm And Guard - Stihl TS 410 Instruction Manual

Assembling the cast arm and
guard
The "cast arm with guard" is mounted on
the inboard side by the manufacturer.
The "cast arm with guard" can also be
mounted on the outboard side
depending on requirements.
Assembly on the inboard side is
recommended for freehand cutting on
account of the better balance.
Outboard mounting
Disassemble the cutting wheel (see
N
"Fitting / replacing an cutting wheel")
Remove water attachment
1
2
Unscrew the banjo bolt (1) with the
N
combination wrench – in the
process, remove the square nut
from the inside of the guard from the
guide
Remove the water hose (2) with
N
connector from the adjusting
lever (3)
Pull the water hose (2) out of the
N
guide (arrows) in the V-belt guard
TS 410, TS 420
Removing the adjusting lever
3
Unscrew the banjo bolt (1) with the
N
combination wrench and remove it
together with the seal – in the
process, remove the square nut
from the inside of the guard from the
guide
Remove screw (2)
N
Turn the adjusting lever (3) upwards
N
and remove
3
Slackening the V-belt
1
1
1
1
Unscrew the nuts (1) – do not
N
remove them
Turn the tensioning nut (2)
N
counterclockwise with the
combination wrench –
approx. 1/4 turn, as far as it will
go = 0
2
1
2
0
Removing the V-belt guard
2
1
Remove screw (1)
N
Raise the V-belt guard (2) slightly
N
and pull it off to the front
3
Remove the V-belt (3) from the front
N
pulley (4)
English
4
19