Fitting / Replacing An Abrasive Wheel - Stihl TS 410 Instruction Manual

WARNING
The tensioning nut is spring-loaded –
hold the combination wrench securely.
Turn the tensioning nut clockwise
N
approx. 1/8 turn – the tensioning nut
will be engaged by the spring
Continue turning approx. 1/8 turn –
N
up to the stop
NOTICE
Do not turn the combination wrench
further by force.
The ribbed V-belt is automatically
tensioned by the force of the spring in
this position.
Remove the combination wrench
N
from the tensioning nut
Tighten up the nuts (1)
N
Retensioning the ribbed V-belt
1
1
1
The V-belt is retensioned without the aid
of the tensioning nut.
Undo the nuts (1)
N
The V-belt is automatically tensioned by
the force of the spring.
Tighten up the nuts (1) again
N
TS 410, TS 420
Fitting / replacing an abrasive
wheel
The engine must be switched off for
fitting or replacement – set slide control
to STOP or 0.
Blocking the shaft
1
Slide the locking pin (1) through the
N
bore in the V-belt guard
Turn the shaft with the combination
N
wrench until the locking pin (1)
engages in the bore behind the
guard
Removing a cutting wheel
2
Use the combination wrench to
N
loosen and remove the hexagon
head screw (2)
Remove the front thrust washer (3)
N
from the shaft together with the
cutting wheel
English
23