Fuel - Stihl TS 410 Instruction Manual

English
Fitting a new cutting wheel
4
Fit the new cutting wheel (4)
N
WARNING
Note the arrows indicating the direction
of rotation on diamond cutting wheels.
Fit the front thrust washer (3). The
N
catches of the front thrust
washer (3) must engage in the shaft
grooves.
Screw in the hexagon bolt and
N
tighten it with the combination
wrench – if using a torque wrench,
refer to the "Specifications" for the
tightening torque
Draw the locking pin out of the
N
V-belt guard
24
WARNING
Never use two cutting wheels at the
same time. The uneven wear creates a
risk of breaking and an injury hazard!

Fuel

Your engine requires a mixture of
gasoline and engine oil.
WARNING
For health reasons, avoid direct skin
contact with gasoline and avoid inhaling
gasoline vapor.
STIHL MotoMix
STIHL recommends the use of STIHL
MotoMix. This ready-to-use fuel mix
contains no benzol or lead, has a high
octane rating and ensures that you
always use the right mix ratio.
STIHL MotoMix uses STIHL HP Ultra
two-stroke engine oil for an extra long
engine life.
MotoMix is not available in all markets.
Mixing Fuel
NOTICE
Unsuitable fuels or lubricants or mix
ratios other than those specified may
result in serious damage to the engine.
Poor quality gasoline or engine oil may
damage the engine, sealing rings, hoses
and the fuel tank.
Gasoline
Use only high-quality brand-name
gasoline with a minimum octane rating
of 90 – leaded or unleaded.
TS 410, TS 420