Spark Arresting Screen In Muffler; Spark Plug - Stihl TS 410 Instruction Manual

English
Spark Arresting Screen in
Muffler
In some countries, the mufflers are fitted
with a spark arresting screen.
If engine performance deteriorates,
N
check the spark arresting screen in
the muffler
WARNING
Wait until engine has cooled completely
before performing the following
operations.
2
1
Remove screw (1)
N
Pull the spark arresting screen (2)
N
upwards out of the muffler
Clean the soiled spark arresting
N
screen
If the screen is damaged or heavily
N
carbonized, fit a new one
Refit the spark arresting screen in
N
reverse order of steps
32

Spark Plug

If the engine is down on power,
N
difficult to start or runs poorly at idle
speed, first check the spark plug.
Fit a new spark plug after about 100
N
operating hours – or sooner if the
electrodes are badly eroded. Install
only suppressed spark plugs of the
type approved by STIHL – see
"Specifications".
Removing the spark plug
Switch off the engine – move stop
N
switch to STOP or 0
2
Unscrew screw (1) and remove
N
cap (2) – screw (1) is secured in the
cap (2) to prevent loss
3
4
Remove the spark plug boot (3).
N
Unscrew the spark plug (4).
N
Checking the spark plug
Clean dirty spark plug.
N
Check electrode gap (A) and
N
readjust if necessary – see
"Specifications".
Rectify the problems which have
N
caused fouling of the spark plug.
Possible causes are:
Too much oil in fuel mix.
–
1
Dirty air filter.
–
Unfavorable running conditions.
–
WARNING
If the spark plug comes with a
detachable adapter nut (1), screw the
adapter onto the thread and tighten it
down firmly to reduce the risk of arcing
and fire.
A
1
TS 410, TS 420