Assemble The Oil Pump; Releasing Air In The Oil Pump - PGO PMX Sport 50 Service Manual

5.Assemble the oil pump.

a. Assemble the oil pump by reversing
Above procedure.
O-ring of oil pump sho uld be lubricated by
Grease or oil, then place on cankcase.
The contact surface of oil pump and crank
Case should be assembled firmly.
The gears of oil pump should be lubri-
Cated by grease.
b. Be sure oil pump screw is tightened nitely
Locking torque:0.8~1.2kg- m
After assmebling, check the following:
a. the adjustment of control cables
b. Is there air in oil pipe.
c. oil leakage at any location.

6.Releasing air in the oil pump.

a. If there is air in the oil pipe, it will cause engine lubrication trouble
b. Releasing air operation means the release of air trapped in the air
pipe oil pipe and oil pump. Please firstly release air from the oil pipe
(a)Fill up specific amount of oil to oil tank.
(b)Place dry cloth under the oil pump.
© Remove oil pipe.
(d)Use injector to fill up the oil in the
oil pump body and oil pipe. Be sure the oil
pipe and oil pump are full of oil before
assembling.
(e)After assembling, check if there is still air
trapped in the oil pipe.