Paper Cutting Failed; End Of Paper Feed; Rel Lever Is In Wrong Position; Borderless Printng Not Possible - Canon iPF850 series Basic Manual

Paper cutting failed.

•
To disable this message (if it is displayed repeatedly despite reloading paper, for example), choose Off or Loose
in the Skew Check Lv. setting of the printer menu. However, this may cause jams and printing problems be-
Important
cause paper may be askew when printed. Also, the Platen may become soiled, which may soil the back of the
next document when it is printed.
Paper cutting failed.
Paper cutting failed.
Cause
There are sheets left on
the Ejection Guide.
There is a foreign object
by the Output Tray, ob-
structing the Cutter Unit.
You are not using the
printer under the recom-
mended environmental
conditions for the paper.
You are using paper that
is not compatible with au-
tomatic cutting.
The Cutter Unit stops in
the middle of cutting.
In other cases, the Cutter
Unit may be damaged.

End of paper feed.

End of paper feed.
Although an attempt was made to advance the paper manually, it reached
the limit position that can be advanced.

Rel lever is in wrong position.

Rel lever is in wrong position.
Cause
The Release Lever is up.

Borderless printng not possible.

Borderless printng not possible.
Cause
The print job received specifies
a type or width of paper that is
not compatible with borderless
148
printing.
1.
Lift the Release Lever and remove the paper.
2.
If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press
the OK button.
Printing will resume, starting from the page on which the error occurred.
1.
Lift the Top Cover and remove the foreign object.
2.
If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press
the OK button.
Printing will resume, starting from the page on which the error occurred.
Use the printer only where the recommended environmental conditions for the paper are met. Note
that various environmental conditions are recommended for various types of paper. For details on the
recommended environmental conditions for paper, see the Paper Reference Guide.
(See "Displaying the Paper Reference Guide.")
Specify Manual as the cutting method and cut the roll manually.
(See "Specifying the Cutting Method for Rolls.")
For information about paper that is compatible with automatic cutting, see the Paper Reference
Guide.
(See "Displaying the Paper Reference Guide.")
If the Carriage is out, move the Carriage out of the way, away from the paper.
If the Cutter is out, move the Cutter to the right side (away from the paper) and remove the jammed
paper.
(See "Clearing Jammed Roll Paper.")
If the paper cannot be cut using the Cutter Unit, specify Manual as the roll cutting method and cut the
roll manually.
(See "Specifying the Cutting Method for Rolls.")
Contact your Canon dealer for assistance.
Cause
Lower the Release Lever.
If the error occurs again, turn off the printer and wait a while before restoring power.
Follow these steps to change the settings of the print job to enable borderless printing.
1.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
2.
Make sure the correct printer driver for the printer is selected and try printing again.
For information on types of paper compatible with borderless printing, refer to the Paper Ref-
erence Guide.
Corrective Action
User's Guide
➔
User's Guide
➔
User's Guide
➔
P.111
➔
User's Guide
➔
Canceling manual advancing.
(See "Feeding Roll Paper Manually.")
Corrective Action
Corrective Action
iPF850 Series
Corrective Action
User's Guide
➔
Basic Guide