Table of Contents
Advertisement
2.
At the prompt, type RSET8139.EXE and press <Enter>. The Ether-
net configuration program will then be displayed.
3.
This simple screen shows all the available options for the Ethernet
interface. Just highlight the option you wish to change by using the Up
and Down keys. To change a selected item, press <Enter>, and a screen
will appear with the available options. Highlight your option and press
<Enter>. Each highlighted option has a helpful message guide displayed
at the bottom of the screen for additional information.
4.
After you have made your selections and are sure this is the config-
uration you want, press ESC. A prompt will appear asking if you want to
save the configuration. Press Y if you want to save.
The Ethernet Setup Menu also offers three very useful diagnostic func-
tions. These are:
1.
Run EEPROM Test
2.
Run Diagnostics on Board
3.
Run Diagnostics on Network
Each option has its own display screen that shows the format and result of
any diagnostic tests undertaken.
Note 1:
For Ethernet installation, please see Chapter 6.
23
Chapter 3
Advertisement
Table of Contents
