Turning On The Power (Standby) - Pioneer PDP-5050SX Operating Instructions Manual

07 Basic Operations

Turning on the power (Standby)

1
Confirm that the ON/DATA indicator is lighting up
orange, and then press POWER on the Plasma Display.
• The Plasma Display enters the standby mode
(STANDBY indicator: red) or turns on (ON/DATA
indicator: green).
• Proceed to Step 2 below if the Plasma Display is in the
standby mode.
2
If the STANDBY indicator lights up red, press TV
the remote control unit or STANDBY/ON on the Plasma
Display to turn the Plasma Display on.
• The ON/DATA indicator on the Plasma Display lights
up green.
Turning off the power (Standby)
1
Press TV on the remote control unit or STANDBY/ON
on the Plasma Display.
• The Plasma Display enters the standby mode and the
image on the screen disappears.
• STANDBY indicator lights up red.
• It is recommended to place the Plasma Display into the
standby mode by pressing TV
unit. This allows the Plasma Display to automatically
receive digital TV program information in the standby
mode.
• If you are not going to use this Plasma Display for a long period of
time, remove the power cord from the power outlet.
Plasma Display status indicators
ON/DATA Indicator Status
Orange
For other than the above, see "Troubleshooting" on page 53.
20
En
07-PDP5050SX-Eng (20-25)
on
on the remote control
STANDBY
Indicator Status
Green Red
20
Plasma Display
ON/DATA indicator
POWER button
(right view)
STANDBY/
ON button
System Status
The power cord has been disconnected.
The power cord is connected, but the remote control operation is not
possible.
The Plasma Display is in the standby mode.
The power to the Plasma Display is on.
05.2.25, 0:24 PM
STANDBY indicator