Pioneer PDP-5050SX Operating Instructions Manual page 17

Preparation
Allowed operation range of the remote control
unit
Operate the remote control unit while pointing it toward the
remote control sensor (
front panel of the Plasma Display. The distance from the remote
control sensor must be within 7 m (23 feet) and the angle
relative to the sensor must be within 30 degrees in the right or
left direction.
30°
Cautions regarding the remote control unit
• Do not expose the remote control unit to shock, liquid, or
high humidity.
• Do not place the remote control unit under direct sunlight;
the unit may deform.
• The remote control unit may not work properly if the remote
sensor window of the Plasma Display is under direct sunlight
or strong lighting. In such case, change the angle of the
lighting or Plasma Display, or operate the remote control unit
closer to the remote sensor window.
• When any obstacle exists between the remote control unit
and the remote control sensor, the remote control unit may
not function.
• As the batteries become empty, the remote control unit can
function within a shorter distance from the remote control
sensor. Replace the batteries with new ones if necessary.
• The Plasma Display emits very weak infrared rays from its
screen. If you place such equipment operated through
infrared remote control as a VCR nearby, that equipment may
not receive commands from its remote control unit properly
or entirely. If this is the case, place that equipment at a
location far enough from the Plasma Display.
• Depending on the installation environment, infrared rays
from the Plasma Display may not allow this system to
properly receive commands from the remote control unit or
may shorten allowable distances between the remote control
unit and the remote control sensor. The strength of infrared
rays emitted from the screen differs, depending on images
displayed on the screen.
06-PDP5050SX-Eng (14-19)
) located at the bottom right of the
Remote control
30° sensor
17
Cable connections for watching digital
and/or conventional TV channels
This Plasma Display is equipped with two terminals for input-
ting TV broadcasting signals: ANTENNA/CABLE A IN and
ANTENNA B. The ANTENNA/CABLE A IN terminal accepts both
digital and conventional TV broadcasting signals while the
ANTENNA B terminal accepts only conventional TV broadcast-
ing signals. When using a cable TV to watch digital and/or
conventional TV channels, connect to the ANTENNA/CABLE A
IN terminal as shown. In addition, you may connect an antenna
to the ANTENNA B terminal as shown; use an outdoor antenna
to enjoy clearer pictures. If your outdoor uses a 75-ohm coaxial
cable with an F-type connector, plug it into the antenna
terminal at the rear of the Plasma Display.
Connecting VHF/UHF antennas and a Cable
Converter
Plasma Display (rear)
Cable TV Splitter
Cable Converter
Plasma Display (rear)
• Be sure to connect coaxial cables as shown above. Signal reception
may fail if not properly connected.
05.2.25, 0:15 PM
ANTENNA/
CABLE A IN
ANTENNA B
IN
OUT
06
17
En