Naming Tv Channels; Checking Signal Strength - Pioneer PDP-5050SX Operating Instructions Manual

09 Tuner Setup

Naming TV channels

You can name TV channels that you have set up for antenna B.
This may help you easily identify the channels during selections.
1
Press HOME MENU.
2
Select "Tuner Setup". ( /
3
Select "Channel Setup". ( /
4
Select "Ant. B". ( /
5
Select "Name Channel". ( /
6
Select a channel. ( /
• You can also use buttons 0 – 9 to enter a channel
number.
Channel Setup Ant. B
Ant. B Name Channel
7
Enter up to 7 alphanumeric characters using
/ , and ENTER.
• To clear the last character, press B.
Channel Setup Ant. B
Ant. B Name Channel
Accept
A
8
Press A.
9
Press HOME MENU to exit the menu.

Checking signal strength

When you have selected antenna A, you can check the current
channel's signal strength. You may use this function when
receiving a channel through a VHF/UHF antenna.
1
Press HOME MENU.
2
Select "Tuner Setup". ( /
3
Select "Channel Setup". ( /
4
Select "Ant. A". ( /
5
Select "Signal Strength". ( /
Channel Setup Ant. A
Ant. A Signal Strength
• Adjust the direction of the antenna so that the current
signal strength reaches as close to the maximum signal
strength as possible.
6
Press HOME MENU to exit the menu.
28
En
09-PDP5050SX-Eng (27-35)
then ENTER)
then ENTER)
then ENTER)
then ENTER)
then ENTER)
Name Channel
xxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxx
Home Menu Exit
/ ,
Name Channel
Name: DTV2
xxxxxxxxxxxxxxxxxxxxx
A B C D E F G H I J
K L M N O P Q R S T
xxxxxxxxxxxxxxxxxxxxx
U V W X Y Z 1 2 3 4
xxxxxxxxxxxxxxxxxxxxx
5 6 7 8 9 0 . @ / (
) , – _ : ' &
S P A C E
Clear Cancel Home Menu Exit
B D
then ENTER)
then ENTER)
then ENTER)
then ENTER)
Signal Strength
Maximum: 100
xxxxxxxxxxxxxxxxxxxxx
Current: 100
xxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxx
Home Menu Exit
28
Checking the Cable Card ID
The Plasma Display has a slot for a cable card that is used for
managing your information by the cable TV company. The
following procedure allows you to check your Cable Card ID and
the Host ID.
1
Press HOME MENU.
2
Select "Tuner Setup". ( /
3
Select "Channel Setup". ( /
4
Select "POD ID". ( / )
• The Host ID and Cable Card ID appear.
5
Press HOME MENU to exit the menu.
05.2.25, 10:15 AM
then ENTER)
then ENTER)