Display Results Mode; Ride Mode; Service Mode - Schwinn MPower Echelon2 Console Owner's Manual

Display Results Mode

To stop the workout and go to Display Results Mode, push the AVG/MAX button and hold it
down for 3 seconds or longer. The console shows total Calories, total time and distance, and
the Max and Average values. After 2 minutes the console sets the values back to zero and
goes into Sleep Mode.
Push the ON/OFF button and hold for 3 seconds to exit Display Results Mode and go to Sleep
Mode.

Ride Mode

When the console is powered on and rider begins to pedal, the console is in Ride Mode.
When the cadence decreases to zero, the console pauses and the LCD display shows the
last workout data values. If you stay paused for more than 5 minutes, the workout ends and
the console goes into Display Results Mode.
To start the STAGE time, distance and power calculations, tap the STAGE button. Values will
calculate until the STAGE button is tapped again, at which time the values will freeze on the
display. Tap the STAGE button again to clear the values and begin a new stage.
At any time while in Ride Mode, access Maximum and Average values by pressing AVG/MAX
button. One press will display Average values, a second press will display Maximum values.
Display will return to workout values after 3 seconds, or with a third push.
To end the workout, push the AVG/MAX button and hold for 3 seconds. The console goes to
Display Results Mode.
To turn off the console, push the ON/OFF button and hold for 3 seconds.

Service Mode

The Service Mode menu lets Service Technicians set the bike configurations, see
maintenance data, do calibrations and upgrade the console firmware.
• To go to Service Menu, push and hold the STAGE and AVG/MAX buttons for 5 seconds
• To scroll through the Service Mode menu and sub menu options, tap the STAGE or AVG/
MAX button
• To make selections and go to submenu options, push the Backlight button
• To exit Service Mode, tap the STAGE or AVG/MAX button until you see the EXIT option, then
push the Backlight button
Note: RPM must be 0 to enter Service Mode.
For detailed instructions on how to configure, calibrate, and update firmware, refer to the
Installation Instructions included on the CD that is in the console kit. Or go to the Schwinn
Equipment website at www.schwinnequipment.com/customer-resources and search for
product information on the Echelon2.
Gear
This option sets the GEAR function to ON or OFF.
Operations
10
Owner's Manual