Display Results; Device Pairing - Schwinn MPower Console V2 + Power Owner's Manual

Display Results

2. Push the STAGE and AVG/END buttons for 5 seconds to go to Service Mode.
3. Tap the AVG/END button until you see the Power menu option, and push the Backlight button.
4. Push the STAGE or AVG/END button to see the Power submenu options—Sport (not power enabled) and Perform (power enabled).
• • •
If you have a Power Sensor, go to the Perform option and push the Backlight button to set.
• • •
If there is no Power Sensor, go to the Sport option and push the Backlight button to set.
5. The console goes back to the Service Mode menu and the Power menu option appears.
6. Make sure that the switch (U) on the Speed Sensor is set to S (speed).
7. Push the pairing buttons on the Console (L1), the Speed Sensor (L2) and the Power Sensor (L3), if applicable.
8. The console display shows PPP and the time display counts down from 0:35 (seconds).

Device Pairing