Checking The Drive Bay Setup - Supero SUPERSERVER 6025B-TR+ User Manual

S S
UPER ERVER 6025B-TR+/6025B-8R+ User's Manual
2-6

Checking the Drive Bay Setup

Next, you should check to make sure the peripheral drives and the Serial ATA drives
have been properly installed and all connections have been made.
1. Accessing the drive bays
All drives are accessable from the front of the server. For servicing the DVD-ROM
and fl oppy drives, you will need to remove the top chassis cover. The Serial ATA
disk drives can be installed and removed from the front of the chassis without
removing the top chassis cover.
2. DVD-ROM and fl oppy disk drives
A slim DVD-ROM and a fl oppy drive should be preinstalled in your server. Refer
to Chapter 6 if you need to reinstall a DVD-ROM and/or fl oppy disk drive to the
system.
3. Check the SATA/SCSI drives
Depending upon your system's confi guration, your system may have one or more
drives already installed. If you need to install SATA/SCSI drives, please refer to
Chapter 6.
4. Check the airfl ow
Airfl ow is provided by four 8-cm center chassis cooling fans. An air shroud is also
included in the system to maximize airfl ow. The system component layout was
carefully designed to direct suffi cient cooling airfl ow to the components that gener-
ate the most heat. Note that all power and data cables have been routed in such
a way that they do not block the airfl ow generated by the fans.
5. Supplying power to the system
The last thing you must do is to provide input power to the system. Plug the power
cord(s) from the power supply unit(s) into a high-quality power strip that offers pro-
tection from electrical noise and power surges. It is recommended that you use an
uninterruptible power supply (UPS).
2-10