Renault Lodgy Driver's Handbook Manual page 103

CRUISE CONTROL/SPEED LIMITER: cruise control function
3
2
4
Putting the function on
standby
The function is set to standby if you:
– use the switch 5 (O);
– the brake pedal;
– the clutch pedal;
In all three cases, the cruising speed
remains stored and, depending on the
vehicle, the message "MEM" or the
warning light appear on the instru-
ment panel. Standby is confirmed by
the warning light going out.
ENG_NU_975-8_X92_Dacia_2
Jaune Noir
Returning to the cruising speed
If a speed is stored, it can be recalled,
once you are sure that the road con-
ditions are suitable (traffic, road sur-
face, weather conditions, etc.). Press
5
switch 4 (R) if the vehicle speed is
above 20 mph (30 km/h).
When the stored speed is recalled, acti-
vation of the cruise control is confirmed
by the illumination of the
light.
NB: if the speed previously stored is
much higher than the current speed,
the vehicle will accelerate more rapidly
to reach this threshold.
When the cruise control function is
put on standby, pressing switch 2
(+) reactivates the cruise control
function without taking into account
the stored speed: it is the speed at
which the vehicle is moving that is
taken into account.
Noir texte
(4/4)
warning
Switching off the function
The cruise control function is deacti-
vated if you press switch 1: in this case
a speed is no longer stored. The two in-
strument panel warning lights
go out to confirm that the function is
deactivated.
must brake by depressing the brake
pedal.
ENG_UD38216_3
Régulateur-limiteur de vitesse : fonction régulateur (X92 - Dacia)
1
and
Putting the cruise control
on standby or switching it
off does not cause a rapid
reduction in speed: you
2.33