Table of Contents
Advertisement
4
Step
Install
Anti-Tip
• Mount brackets provided using #12 or #14
Brackets
• Screws must protrude at least one inch into
• Attach a 36" long 2x4 block to brackets as
Roll Refrigerator Into Opening
• Gently push refrigerator into opening with
• Roll refrigerator into the opening until it is
Important Note: If your installation situation does not allow
enough height for this method of security, use step 6 as an
alternate. The refrigerator must be secured to prevent tipping.
5
This refrigerator has 4-point leveling. The
front is supported by leveling legs, the rear is
Step
supported by wheels.
• Adjust rear wheels beneath the refrigerator
Level
• Turn the 7/16" hex nut located above the
Refrigerator
• For front leveling legs, use the 1-1/2" open-
• Adjust carefully, the refrigerator should be
6
Step
Note: Whenever possible,
perform this step for additional
anti-tip security. This step can be
used as an alternate to Step 4,
Anti-Tip bracket installation,
Optional
whenever brackets cannot be
Anti-Tip
used.
Precaution
When using 1/2" to 3/4" side panels, the
front flange of the case trim is attached to the
side panel.
• Open fresh food door to access case trim.
• Drill hole in trim below fresh food opening.
• Follow the same procedure on opposite side.
CAUTION
WARNING
ANTI-TIP PRECAUTIONS
The refrigerator is heavy at the top and must be
secured to prevent the possibility of tipping
forward.
wood screws located 83-1/2" from the
finished floor.
vertical wall studs.
shown.
hands against front corners. The cardboard
protective pad should be beneath the
refrigerator.
flush or semi-flush with adjacent cabinets.
to just barely touch the 2x4 block.
front wheels. Turn to raise or lower the
refrigerator.
end wrench (provided).
level and plumb with cabinetry, and should
align with toekick height.
Drive screw through trim and side panel.
Installation
36" Stainless Bottom Mount Refrigerators
Note: If you are
installing under a
soffit, attach brackets
to wood block before
mounting the brackets
to the rear wall.
83-1/4" From Floor
Wood Screws Mounted into
Vertical Wood Studs
Hex Nut Adjusts
Rear Wheels
Stud
OR
If refrigerator is installed between cabinets
with no side panels or in a custom enclosure,
install a spacer block as shown.
• Open fresh food door to access case trim.
• Drill hole in trim below fresh food opening.
Drive screw through trim and into block.
• Follow the same procedure on opposite side.
2 x 4
Block
83-1/2"
36" Wide
From floor
to bottom
of wood block
Mounting Bracket
2 x 4 Cut
To 36" Length
Leveling Leg
Refrigerator
Cabinet
Door
Spacer
Block
10
Advertisement
Table of Contents
