Table of Contents
Advertisement
7
Check to be sure that refrigerator power cord
is not plugged into the wall outlet.
Step
• Locate and bring copper tubing to the front
Connect
• The copper tubing should be just long
Water
Supply
• Slip a 1/4-1/4 union nut (provided) over
• Turn on the water to check for leaks.
8
Step
Connect
Power
9
Step
Mount
Top Grille
Panel
of the cabinet.
enough to reach the coupling. Excess tubing
length could interfer with drawer closing or
toekick installation.
both ends of the copper tubing at the right
front leg of the refrigerator and couple the
lines.
• Connect the refrigerator power cord plug
to properly grounded receptacle, accessible
through the top left side of the hood
opening.
• Check to make sure power to refrigerator is
on by opening refrigerator door to see if
interior lights are on.
• For shipping purposes, the top case trim is
secured at 84" installation height.
To raise case trim to 84-1/2" installation
height or to lower case trim to 83-1/2":
• Loosen 2 screws on both sides and raise or
lower the top case trim to meet soffit
height or to the top of adjacent cabinets.
• Tighten all 4 screws.
• Mount the grille panel by dropping into
slots on the case trim.
The grille panel assembly is factory set for an
84" installation height. If installation height
is 83-1/2" or 84-1/2", order ZGCSS36RH
(right hand) or ZGCSS36LH (left hand)
grille panel kit.
Installation
36" Stainless Bottom Mount Refrigerators
Top
Case
Trim
Raise To
Installation
Height
1-1/2"
min.
gap
Important: Maintain 1-1/2" min. gap between top of
doors and bottom of grille panel.
Screws
11
Advertisement
Table of Contents
