Sample Applications - Stihl TS 700 Instruction Manual

English
snugly onto spark plug terminal of the
proper size. (Note: If terminal has a
detachable SAE adapter nut, it must be
attached.) A loose connection between
spark plug terminal and ignition wire
connector in the boot may create arcing
that could ignite combustible fumes and
cause a fire. Keep spark plug clean, and
make sure ignition lead is in good
condition.
WARNING
Do not operate your cut-off machine if
the muffler is damaged, missing or
modified. An improperly maintained
muffler will increase the risk of fire and
hearing loss. Never touch a hot muffler
or spill fuel or other flammable liquid
over it. Burn injuries or fire will result. If
your muffler was equipped with a spark-
arresting screen to reduce the risk of fire
(e. g. in the USA, Canada and
Australia), never operate your cut-off
machine if the screen is missing or
damaged.
In California, it is a violation of § 4442 or
§ 4443 of the Public Resources Code to
use or operate gasoline-powered tools
on forest-covered, brush-covered or
grass-covered land unless the engine's
exhaust system is equipped with a
complying spark arrester that is
maintained in effective working order.
The owner/operator of this product is
responsible for properly maintaining the
spark arrester. Other states or
governmental entities/agencies, such as
the U.S. Forest Service, may have
similar requirements. Contact your local
fire agency or forest service for the laws
or regulations relating to fire protection
requirements.
16
For any maintenance please refer to the
maintenance chart and to the warranty
statement near the end of the instruction
manual.
Store wheels on a flat surface in a dry
place, preferably at a constant
temperature, where there is not a risk of
frost. Do not store a cut-off machine with
a wheel mounted on the machine. Store
cut-off machine in a high or locked
place, away from children.
Empty the fuel tank before storing for
longer than a few days. Store fuel only in
correctly labeled and approved
containers. Avoid direct skin contact and
do not inhale the gas vapors.

Sample applications

Water connection
A water attachment kit is mounted
–
on the machine for use with all types
of water supply.
A pressurized 2.6 gallons (10 liter)
–
water tank is available from STIHL
for wet cutting.
A water tank for mounting on the
–
Cutquik cart is also available for wet
cutting.
Most diamond cutting wheels are
suitable for wet cutting
Wet cut whenever feasible. It increases
the service life and cutting speed of
diamond cutting wheels.
Ensure that the cutting wheel is
generously supplied with water.
Wet cutting helps to suppress dust.
The water binds the dust.
The cutting wheel must be supplied with
at least 20 fl. oz (0.6 liters) water per
minute.
Wet cutting can reduce the energy of
reactive forces. In a pinch situation, the
water can act as a lubricant.
TS 700, TS 800