Installation
About Status Indicators
The status of the scanner is displayed by the ready indicator (A) and the error indicator (B), as shown in the
table below:
A Ready indicator
(Green)
ON
ON
OFF
Blinking (Slow, Long ON)
Blinking (Slow, Long ON)
Blinking (Slow, Short ON)
Blinking (Slow, Short ON)
Blinking (Fast)
*3
Blinking (2 times consecutively)
*1
On for 1 second and off for 1 second.
*2
On for 1 second and off for 3 seconds.
*3
On for 0.25 seconds and off for 0.25 seconds.
*4
Check the status of the scanner using User Utility.
*5
The scanner will enter Standby mode when no operation is performed for 30 minutes, to save power.
To use the scanner again, restart it by pressing any one of the buttons for more than 1 second. The time period before the scanner
enters Standby mode can be configured in User Utility.
(The default setting varies depending on the country/area.)
16
Installation Manual
1
2
OFF
Blinking (Slow, Long ON)
ON
OFF
*1
Blinking (Slow, Long ON)
*1
OFF
*2
Blinking (Slow, Long ON)
*2
OFF
OFF
B Error indicator
(Red)
*1
*1
*1
Status
Ready
Caution
*4
Error
*4
Sleep
Caution
/ Sleep
*4
Standby
*5
Caution
/ Standby
*4
*5
Warming up
Double Feed Skip mode