Location of Controls
About Status Indicators
The status of the scanner is displayed by the ready indicator ( 1 ) and the error indicator ( 2 ), as shown in the
table below:
1 Ready indicator ( )
(Green)
ON
ON
OFF
Blinking (Slow, Long ON)
Blinking (Slow, Short ON)
Blinking (Fast)
*3
On for 2 seconds and off for 2 seconds.
*1
On for 1 second and off for 3 seconds.
*2
On for 0.5 seconds and off for 0.5 seconds.
*3
Check the status of the scanner using User Utility. For details about User Utility, refer to the User Utility Reference Manual.
*4
The scanner will enter Standby mode when no operation is performed for 30 minutes, to save power.
*5
To use the scanner again, restart it by pressing any one of the buttons for more than 1 second. The time period before the scanner
enters Standby mode can be configured in User Utility.
(The default setting varies depending on the country/area.)
18
Operating Manual
1
2
2 Error indicator ( )
OFF
Blinking (Slow, Long ON)
ON
OFF
*1
OFF
*2
OFF
(Red)
Ready
Caution
*1
Error
Sleep
Standby
Warming up
Status
*4
*4
*5