Pci/Plug Setup Page - PC Chips A41G V7.0 User Manual

Motherboard User's Guide
Resume By USB (S3)
This item allows you to enable/disable the USB device wakeup function from S3 mode.
Resume By PS2 KB (S3)
This item enables or disables you to allow keyboard activity to awaken the system
from power saving mode.
Resume By PS2 MS (S3)
The system can be turned off with a software command. If you enable this item,
system can automatically resume by pressing any keys or power keys on the
keyboard, or typing in the password. You must use an ATX power supply in
order to use this feature.
Resume on RTC Alarm
The system can be turned off with a software command. If you enable this item, the
system can automatically resume at a fixed time based on the system's RTC (realtime
clock). Use the items below this one to set the date and time of the wake-up alarm. You
must use an ATX power supply in order to use this feature.
PCI / Plug Setup Page
This page sets up some parameters for devices installed on the PCI bus and those
utilizing the system plug and play capability.
CMOS Setup Utility – Copyright (C) 1985-2005, American Megatrends, Inc.
Allocate IRQ to PCI VGA
Init Display First
: Move Enter: Select
F1: General Help
Allocate IRQ to PCI VGA
If this item is enabled, an IRQ will be assigned to the PCI VGA graphics system.
You set this value to No to free up an IRQ.
Init Display First
Use this item to select which graphics controller to use as the primary boot devices.
PCI / Plug and Play Setup
Yes
PCI
YES: Assigns IRQ to
PCI VGA card if card
requests IRQ.
NO: Does not assign
IRQ to PCI VGA card
even if card requests
an IRQ.
+/-/: Value F10: Save Esc: Exit
F9: Load Default Settings
24
Help Item