PC Chips A41G V7.0 User Manual page 16

F_USB1~2: Front Panel USB Headers
The motherboard has USB ports installed on the rear edge I/O port array. Addition-
ally, some computer cases have USB ports at the front of the case. If you have this
kind of case, use auxiliary USB headers F_USB1~2 to connect the front-mounted
ports to the motherboard.
Here is a list of USB pin assignments.
Pin
1 VERG_FP_USBPWR0
3 USB_FP_P0(-)
5 USB_FP_P0(+)
7 GROUND
9 KEY
1. Locate the F_USB1~2 headers on the motherboard.
2. Plug the bracket cable onto the F_USB1~2 headers.
3. Remove a slot cover from one of the expansion slots on the system chassis.
Install an extension bracket in the opening. Secure the extension bracket to
the chassis with a screw.
SPDIFO: SPDIF out header
This is an optional header that provides an S/PDIF (Sony/Philips Digital Interface)
output to digital multimedia device through optical fiber or coaxial connector.
Chapter 2: Motherboard Installation
Signal Pin Signal
2 VERG_FP_USBPWR0
4 USB_FP_P1(-)
6 USB_FP_P1(+)
8 GROUND
10 GROUND
Pin Signal
1 SPDIF
2 +5VA
3 Key
4 GND
13