Table of Contents
Advertisement
L
E
3.
Press
or
press
.
NOTE: The XON character is 17. The XOFF character is
19.
If you have an IBM personal computer, set flow
control to DTR (unless you have XON/XOFF
software).
You will see
Q
4.
Press
to exit to the Setup menu.
Q
5.
Press
to exit to the Main Menu.
NOTE: After changing settings in the Setup Menu, always
return to the Main Menu before turning your
printer off. The printer will not save changes to
these menus if you turn it off before returning to
the Main Menu.
Reset to Default Values
To reset the communication values to the defaults, follow the
steps listed under "Finding Communication Value Options."
Then follow the steps below.
R
1.
Press
until you see
R
to display the flow control you need, then
PORT SETTINGS
<
Flow Control
PORT SETTINGS
<
Reset
Setting the Communication Values
4-7
Advertisement
Table of Contents
