Monarch 9406 Operator's Handbook Manual page 24

9406 Operator's Handbook
The width of the print area is always four inches. When you
move the image to the right or left on the supply, avoid moving
the image outside the four inch print area.
As you move the format to the right , the fields that would move
past the four inch location of the supply "wrap around" and
appear on the left side. Other fields move the full length you
specify. If your supply is less than 4 inches, fields might move
off the supply and not print.
As you move the format to the left , fields that would move off
the format stop at the 0.0" location of the supply. Other fields
move the full length you specify. Making this change can alter
the relative position of the fields.
The default setting for Margin Position is 0. To change the
setting, follow the steps listed under "Finding the Supply
Options." Then follow the steps below.
R
1. Press
E
2. Press
R
3. Use the arrow keys to change the print position. Pressing
increases the value (moves the image toward the right
side of the supply);
toward the left side of the supply). Press the arrow key
once to change by one number at a time.
E
4. Press
will see
3-10
until you see
SUPPLY
< Margin Pos
. You will see the previous setting, for example,
Enter margin pos
[+/-99]: +0
L
decreases it (moves the image
when the number you want is displayed. You
SUPPLY
< Margin Pos