Setting The Hook In Relation To The Feeding Eccentric (After Feeding) - Husqvarna Viking Designer I Service Manual

Settings
2. Setting the hook in relation to the feeding eccentric
(after feeding)
Check
1. The needle shall be in its centre position, straight stitching.
2. Set the needle in its lowest turning postion.
3. The tip of hook (A) shall now be centred behind the needle, and
the tap of the worm gear should be positioned according to fig. 1.
Note! The position of the pin shall be aligned with the frame opening.
Adjustment
1. Loosen screw (B). Remove the hook and set it into its correct position.
Note! The position of the pin shall be aligned with the frame opening.
104 72 47-26
17