Stop Right Circuit Board - Husqvarna Viking Designer I Service Manual

Dismantling and mounting

Stop right circuit board

Dismounting
1. Dismount rear cover .
2. Dismount front cover .
3. Disconnect the stop right board cable from the circuit board
3. Dismount the screw (A) thats holds the stop right circuit board.
4. Cautiously remove the circuit board from the support by bending its lower end
outwards and thereafter pulling it downwards .
A
NOTE! Check that the lower shaft sensor is mounted at a distance of approx. 1 mm from
the screen. ( see illustation.)
104 72 47-26
45