Feed Dog - Husqvarna Viking Designer I Service Manual

Dismantling and mounting

Feed dog.

Dismounting
1. Dismount the feeding unit.
2. Dismount the feed dog frame from the feed unit .
3. Dismount the feed dog by removing the 2 screws (A).
Mounting
1. Press the feed dog and the feed dog frame against a straight sureface. See Fig 1.
2. Tighten the 2 screws (A).
3. Mount the feed dog frame on the feed unit
4. Mount the feed unit.
Set thereafter
5. The setting of the feed unit sideways.
13. The setting of the stitch plate (hook cover) in relation to the
needle in the feeding direction
14. The sideways setting of the stitch plate (hook cover) in relation
to the pressarfoot.
18. Feed dog height
20. Stitch length balance, basic setting
21. Pre-setting the step motor of the feed dog
22. Stitch length balance, fine adjustment
104 72 47-26
53