Threading Device - Husqvarna Viking Designer I Service Manual

Settings

19.Threading device

Check
1. Insert a new needle.
2. Bring the needle to its highest turning position.
3. The threader hook shall go smoothly into the needles eye. See Fig 1 and Fig 2.
Adjustment
1. Loosen the the two screws (A) on the back of the threader head (B).
2. Move the thread head (B) so that the threader hook (D) does not touch
the needle heightways (See fig 1)
3. Move the thread hook holder (C) so that the threader hook (D) does not touch
the needle sideways (See fig 2) .
4. Tighten the screws.
NOTE! Both settings are adjusted at the same time
104 72 47-26
32