The Gap Between The Needle And The Hook - Husqvarna Viking Designer I Service Manual

8. The gap between the needle and the hook

Check
1. Set the machine on straight stitching.
2. Insert a new needle 90 in the machine.
3. Rotate hand wheel until the tip of the hook arrives behind the needle.
Check the gap by pressing a small screw driver against the needle.
The gap should be as small as possible, but max 0.15 mm.
Adjustment
If the gap is too large:
1. Loosen the screw (A).
2. Turn screw (B) clockwise until the needle
touches the tip of the hook
3. Turn screw (A) until the gap is correct
If the gap is too small:
1. Loosen the screw (B)
2. Turn screw (A) to make the gap larger
and then loosen the screw (A).
3. Turn screw (B) clockwise until the needle
touches the tip of the hook
4. Turn screw (A) until the gap is correct
NOTE! Always tighten screw (A).
Check!
104 72 47-26
Settings
23