Adjusting The Picture - Sony SLV-EZ70AS/NZ Operating Instructions Manual

Adjusting the picture

Adjusting the tracking
Although the VCR automatically adjusts the tracking when playing a tape
(the
may occur if the tape was recorded in poor condition. If so, manually adjust
the tracking.
Press TRACKING +/– buttons on the VCR to
display the tracking meter. The distortion should
disappear as you press one of the two buttons.
(The
tracking adjustment, eject the tape and reinsert it.
About Adaptive Picture Control (APC)
Adaptive Picture Control (APC) automatically
improves recording and playback quality by
adjusting the VCR to the condition of the video
heads and tape. To maintain better picture quality,
we recommend that you set APC to ON in the SET
UP MENU (with the APC indicator in the display
window lit).
APC playback
The APC function automatically works on all types of tapes, including rental
tapes and tapes that were not recorded with APC.
APC recording
Whenever you insert a tape and first start recording, the VCR adjusts to the
tape using the APC function (the APC indicator flashes rapidly). This
adjustment is retained until the tape is ejected.
To deactivate the APC
Press MENU and select SET UP MENU, then set APC to OFF. The APC
indicator in the display window goes off.
Note
• There is a delay of a few seconds before the VCR actually starts recording while the
VCR analyses the tape. To avoid the delay, first set the VCR to recording pause (the
APC indicator flashes slowly) and press r REC to have the VCR analyse the tape
(the APC indicator flashes rapidly). After the APC indicator stops flashing, press
P PAUSE to start recording immediately. If you press P PAUSE before the APC
indicator stops flashing, the APC function is cancelled.
56
Additional Operations
indicator flashes in the display window, then goes off), distortion
indicator lights up.) To resume automatic
NORMAL TRACKING
Tracking meter
e.g. SLV-EZ70NZ
SET UP MENU
AUDIO MIX ON • OFF
HIFI AUDIO • STD NICAM
APC • ON OFF
: [ ]
SELECT
SET : [ ]