Sony SLV-EZ70AS/NZ Operating Instructions Manual page 21

Disabling unwanted programme positions
After tuning the TV channels, you can disable unused programme positions.
The disabled positions will be skipped later when you press the PROG +/–
buttons. You can also disable unwanted programme positions using the SET
UP CH AND G-CODE menu (page 27).
1
In step 5 on page 20, press programme number button "0" twice to
display the number "0" beside CHANNEL SET.
2
Press OK.
If the picture is not clear
Normally, the Auto Fine Tuning (AFT) function automatically tunes in
channels clearly. If, however, the picture is not clear, you may also use the
manual tuning function.
1
Press PROG +/– to select the programme number for which you cannot
obtain a clear picture.
2
Press MENU, then select TUNER PRESET and press OK.
3
Select FINE TUNING. The fine tuning meter appears.
TUNER PRESET
NORMAL / CATV • NORM
AUTO PRESET
CHANNEL SET 3 5
AFT • ON
FINE TUNING
SET : [ ]
4
Press ?// to get a clearer picture, then press OK.
Note that the AFT (Auto Fine Tuning) setting switches to OFF.
Notes
• The menu disappears automatically if you do not proceed for more than a few
minutes.
• The channel numbers besides CHANNEL SET may not be the same as those in your
area. This is because this VCR's channel search system is based on the fixed TV
system that has the widest channel coverage. If necessary, apply your local channel
numbers to the programme positions (see "Changing programme positions" on
page 25).
Selected programme position
PROG14
CATV
OFF
21
Getting Started