Tv Guide On Screen™ Reminder; Disabling The Automatic Tv Guide On Screen™ Program Guide - Toshiba 32HL95 Owner's Manual

Setting up the TV Guide On Screen™ system
Screen 20: If your VCR stopped playing the tape after testing,
select Yes and press ENTER. Screen 21 appears.
Did your VCR stop playing?
If your VCR did not stop playing the tape after testing and
you want to test the same code again, select Test this code
again and press ENTER.
If you want to test a different code, select No and press
ENTER. Screen 19 appears.
Note: Many VCRs require testing more than one code.
Screen 21: Review the setup information displayed on your TV
screen (an example is shown below).
If the information on your TV screen is correct for your
setup, select Yes, end setup and press ENTER. Screen 22
appears.
If the information is incorrect, select No, repeat setup
process and press ENTER. Screen 1 appears.
Screen 22: Congratulations! You have successfully completed
TV Guide On Screen ™ system setup. Press ENTER to
display screen 23.
34
Chapter 5: TV Guide On Screen™ system setup
Screen 23: This screen provides helpful information on using
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(continued)
your TV Guide On Screen
Press ENTER to exit the TV Guide On Screen
watch TV.
TV Guide On Screen™ Reminder
The TV Guide On Screen ™ system receives program listings
data through your Cable or over-the-air video signal. In
order to receive regular program listing updates, remember
to do the following:
1. Leave the TV in standby mode when it is not in use
(such as overnight or when you are not watching it)
by turning it OFF but leaving the power cord
plugged in.
2. If you have a Cable box connected, leave it ON.
3. If you have a VCR connected, turn it OFF when not
in use. (Do not unplug the power cord.) See page 13
for VCR connection instructions.
4. If you have more than one Cable system in your area,
you may be prompted to select which Cable system's
program data to download. If so prompted, follow the
on-screen instructions.
Disabling the automatic TV Guide
On Screen™ program guide
™
The TV Guide On Screen program guide opens
automatically when you turn on the TV. To disable this
feature:
1. Press TV GUIDE on the remote control to open the
TV Guide On Screen ™
open).
2. Use the x • buttons to select the Setup menu.
3. Use the yz buttons to select Change Default Options, and
then press ENTER.
4. Use the yz buttons to select General Default Option,
and then press ENTER.
5. Set the Auto Guide option to Off.
6. Use the buttons to select Done, and then press
yz
ENTER.
™ system.
™
setup and
system (if it is not already