Manually Adding And Deleting Channels In The Channel Memory - Toshiba 32HL95 Owner's Manual

Programming channels into the TV's channel memory (continued)
Manually adding and deleting channels in
the channel memory
After automatically programming channels into the channel
memory, you can manually add or delete individual channels.
To add or delete channels in the channel memory:
1. Press MENU and open the Setup menu.
2. Highlight Installation and press ENTER. (A new set of
Installation menu icons will appear on-screen, as shown in
step 3).
Setup
Installation
Sleep Timer
On/Off Timer
PC Settings
PC Audio No
HDMI Audio Auto
Gray Level
2
Navigate Back
Select CH RTN EXIT
3. Open the Terrestrial menu, highlight Channel Add/Delete,
and then press ENTER.
Note: If you have a cable box connected to ANT 1 during TV
Guide On Screen™ setup, the Terrestrial menu will not be
accessible and you must then use the TV Guide On Screen™
channel editor to add/delete channels.
Terrestrial
Input Configuration
Channel Program
Channel Add/Delete
Signal Meter
Navigate Select CH RTN Back EXIT
4. The illustration below left shows channels programmed for
the ANT 1 antenna input. To view the list of channels
programmed for Cable box or ANT 2 antenna input, use
y z to select the "ANT 2" or "Cable Box" box and press
ENTER.
Note: "Cable Box" will appear only if you connected a cable
box to your TV.
Channel Add/Delete ANT 1
Analog ANT 1
2
2 - 1 Digital ANT 2
2 - 2 Digital Cable Box
Analog
3
4 Analog
Analog
5
6 Analog
Analog
7 Clear All
7 - 1 Digital Save
Analog Cancel
8
Chapter 6: Setting up your TV
Exit
Exit
Channel Add/Delete Cable Box
Analog ANT 1
1
2 Analog ANT 2
3 Analog Cable Box
Analog
4
5 Analog
Analog
6
7 Analog
Analog
8 Clear All
9 Analog Save
Analog Cancel
10
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
To add a channel to the channel memory:
Highlight the unchecked box next to the channel number
you want to add, and then press ENTER to check the box.
To manually add digital subchannels on a physical channel:
Use the Channel Numbers and the Dash (–/100) on the
remote control to enter the channel number (for example,
56–1).
If the channel is found, the number will be added to the list
and the box will be checked.
If the channel is not found, a message will appear.
To remove a channel from the channel memory:
Highlight the checked box next to the channel number you
want to remove, and then press ENTER to uncheck the
box.
To save your new settings:
Highlight Save and press ENTER.
To revert to your original settings:
Highlight Cancel and press ENTER before saving.
To remove all channels from the channel memory:
Highlight Clear All and press ENTER, and then highlight
Save and press ENTER.
Note:
• This action applies to the current antenna input only. To
delete/add channels on the other input, highlight the input
you want (ANT1 or ANT 2) and press ENTER.
• This action cannot be cancelled unless you highlight Cancel
and press ENTER before saving your changes.
Channel Add/Delete
Analog
2
2 - 1 Digital
2 - 2 Digital
Analog
3
Analog
4
5 Analog
6 Analog
7 Analog
7 - 1 Digital
Analog
8
ANT 1
ANT 1
ANT 2
Cable Box
Clear All
Save
Cancel
37