Connecting A Dvd Player With Colorstream; (Component Video) And A Vcr - Toshiba 32HL95 Owner's Manual

Connecting a DVD player with ColorStream

Your TV has ColorStream ® (component video) inputs.
Connecting a DVD player with component video output (such
as a Toshiba DVD player with ColorStream
enhance picture quality.
You will need:
one signal splitter
two coaxial cables
two sets of standard A/V cables
• For better picture performance, if your VCR has S-video, use an
S-video cable (plus the audio cables) instead of the standard
video cable. However, do not connect both types of video cable to
VIDEO 1 at the same time or the picture performance will be
unacceptable.
• If you have a mono VCR, connect L/MONO on the TV
(VIDEO 1) to your VCR's audio out terminal using the white
audio cable only.
one pair of standard audio cables
one set of component video cables
• You can connect the component video cables (plus audio
cables) from the DVD player to either set of ColorStream
terminals on the TV (HD-1 or HD-2). The ColorStream HD-1
and HD-2 terminals can be used with Progressive (480p,
720p) and Interlaced (480i, 1080i) scan systems. A 1080i
signal will provide the best picture performance.
• If your DVD player does not have component video, see page
16. If your DVD player has HDMI video, see page 19.
To view antenna or Cable channels:
Select the ANT 1 video input source on the TV.*
To view the DVD player:
Turn ON the DVD player. Select the ColorStream HD-1
video input source on the TV.*
To view the VCR:
Turn ON the VCR. Select the VIDEO 1 video input
source on the TV.*
To record a TV program while watching a DVD:
Turn ON the VCR. Tune the VCR to the channel to
record. Select the ColorStream HD-1 video input source
on the TV* to view the DVD.
_____________
*
To select the video input source, press INPUT on the remote control
(see page 56). To program the TV remote control to operate other
devices, see Chapter 3.
The unauthorized recording, use, distribution, or revision of television
programs, videotapes, DVDs, and other materials is prohibited under the
Copyright Laws of the United States and other countries, and may subject
you to civil and criminal liability.
Chapter 2: Connecting your TV
® ) can greatly
DVD player with
component video
Note: The VIDEO/AUDIO OUT terminals output signals from the ANT 1,
ANT 2, VIDEO 1, and VIDEO 2 terminals when the appropriate input
mode is selected.
1. Connect the G-LINK™ cable according to the
2. Make sure the VCR is connected to the A/V OUT
3. Set the VCR to the appropriate line input (refer to your VCR
4. See Chapter 5 for details on setting up the TV Guide
5. See Chapter 7 for details on using the TV Guide
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
®

(component video) and a VCR

From antenna or Cable
IN
Signal splitter
OUT OUT
VIDEO
CH 3
CH 4
TV lower back
panel
Y P P
B R
S-VIDEO COMPONENT VIDEO VIDEO
OUT OUT
To enable the TV Guide On Screen™ system to work
with your cable box and to use the TV Guide
On Screen™ recording features:
instructions on page 21.
terminals on the TV (see illustration).
owner's manual for details), and then turn OFF the VCR.
On Screen™ system.
On Screen™ system.
Stereo VCR
AUDIO
L R
IN from ANT
IN
OUT to TV
OUT
L R
TV upper back panel
AUDIO
OUT
L
R
17