Labeling The Video Input Sources - Toshiba 32HL95 Owner's Manual

Labeling the video input sources

You can label each video input source according to the type of
device you connected to each source, from the following preset
list of labels:
– – (default label)
Cable
DTV
Satellite/DSS
VCR
Laser Disk
DVD
Audio Receiver
Compact Disc
Video Recorder
Hide (to hide an unused input in the Input Selection
window)
Note:
If you set up a cable box in VIDEO 1, that input will be labeled
automatically and cannot be relabeled until you remove the
device from the TV Guide On Screen™ setup.
To label the video input sources:
1. Press MENU and open the Preferences menu.
2. Highlight Input Labeling and press ENTER.
3. Press yz to highlight the video source you want to label.
Preferences
Favorite Channels
Closed Caption Mode CC1
Closed Caption Advanced
Input Labeling
Menu Language English
Home CH Setup
Navigate Back
Select CH RTN EXIT
Input Labeling
Video 1
Video 2
ColorStream HD1
ColorStream HD2
HDMI
PC
ANT 2
Reset
Chapter 8: Using the TV's features
Exit
DVD
Cable
Video Recorder
Hide
DTV
- -
- -
Done
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
4. Press x • to select the desired label for that input source. If
a particular input is not used, you can select "Hidden" as
the label, which will cause that input to be "grayed out" in
the input list and skipped over when you press INPUT on
the remote control.
5. To save the new input labels, highlight Done and press
ENTER. To revert to the factory default labels, highlight
Reset and press ENTER.
Input labeling example:
The screen below left shows the default Input Selection screen
(with none of the inputs labeled). The screen below right is an
example of how you could label the inputs if you had connected
a DVD player to VIDEO 1, Cable TV to VIDEO 2, a video
recorder to ColorStream HD1, and a DTV set-top box to
HDMI. Also note that the ColorStream HD2 input is labeled
"Hidden," which means that the input will be skipped over
when INPUT or TV/VIDEO is pressed.
Input Selection
ANT 1
0 ANT 1
1
Video 1
2 Video 2
3 ColorStream HD 1
4 ColorStream HD 2
5 HDMI
6 PC
7 ANT 2
0 - 7 / INPUT to Select
Input Selection screen
with no inputs labeled
To clear the input labels:
1. Press MENU and open the Preferences menu.
2. Highlight Input Labeling and press ENTER.
3. Highlight Reset and press ENTER.
4. Highlight Done and press ENTER.
Input Selection
ANT 1
0
ANT 1 ANT 1
1 DVD
2 Cable
3 Video Recorder
4 ColorStream HD 2(Hidden)
5 DTV
6 PC
7 ANT 2
0 - 7 / INPUT to Select
Input Selection screen with
all inputs labeled except input 5,
which has been hidden.
57