Table of Contents
Advertisement
Setting up the TV Guide On Screen
Screen 20: If your VCR stopped playing the tape after testing,
select Yes and press ENTER. Screen 21 appears.
If your VCR did not
stop playing the tape
after testing and you
want to test the same
code again, select
"Test this code again"
and press ENTER.
If you want to test a
different code, select No and press ENTER. Screen 19
appears.
Note: Many VCRs require testing more than one code.
Screen 21: Review the setup information displayed on your TV
screen (an example is shown below).
If the information on
your TV screen is
correct for your setup,
select "Yes, end setup"
and press ENTER.
Screen 22 appears.
If the information is
incorrect, select "No,
repeat setup process" and press ENTER. Screen 1 appears.
Screen 22: Congratulations! You have successfully completed
®
TV Guide On Screen
display screen 23.
Screen 23: This screen provides helpful information on using
your TV Guide On Screen
Press ENTER to exit the
TV Guide On Screen
®
setup and watch TV.
34
#01E_031-034_27HL95
34
Black
(E) 27HL95 *Web 213 : 276
Chapter 5: TV Guide On Screen
®
Did your VCR stop playing?
system setup. Press ENTER to
®
system.
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
®
setup
system
(continued)
TV Guide On Screen
The TV Guide On Screen
data through your Cable or over-the-air video signal. In
order to receive regular program listing updates, remember
to do the following:
1. Leave the TV in standby mode when it is not in use
by turning it OFF but leaving the power cord
plugged in.
2. If you have a Cable box connected, leave it ON.
3. If you have a VCR connected, turn it OFF when not
in use. (Do not unplug the power cord.) See page 13
for VCR connection instructions.
4. If you have more than one Cable system in your area,
you may be prompted to select which Cable system's
program data to download. If so prompted, follow the
on-screen instructions.
Note: If the TV power cord is unplugged for an extended period
of time, it may take up to 24 hours with the TV in standby mode
(power cord plugged in and power OFF) to download the
®
TV Guide On Screen
program schedule. It may take up to a
week before an entire program schedule is available.
Turning off the TV Guide On Screen
automatic display feature
After you set up the TV Guide On Screen
program guide will display automatically (by default) when
you turn on the TV. To turn off the automatic program guide:
1. Press TV GUIDE on the remote control to open the
TV Guide On Screen
2. Use the x • buttons to select the Setup menu.
3. Use the yz buttons to select "Change Default Options", and
then press ENTER.
4. Use the
yz
buttons to select "General Defaults", and
then press ENTER.
5. Set the "Auto Guide" option to Off.
6. Use the
yz
buttons to select Done, and then press
ENTER.
05.9.12, 15:36
®
Reminder
®
system receives program listings
®
®
system, the
®
system (if it is not already open).
Advertisement
Table of Contents
