Table of Contents
Advertisement
Connecting Hardware Devices
6
Slide the device into the device bay slot until the rail latches click, indicating that the
device is locked into position.
Locking the SCSI device into position
7
Reinstall the access panel, reconnect all signal and power cables, then turn on the
server. For instructions, read Steps 6 through 9 in
50.
Removing SCSI devices
1
If the server is in operation, shut it down. Then remove the access panel. For
detailed instructions, read Steps 1 through 4 in
Removing a SCSI device while the power is on may damage the server and the
SCSI device.
2
Depress the rail latches located on both sides of the SCSI device, then partially slide
the SCSI device out of the device bay slot.
3
Disconnect the power and signal cables.
Disconnecting the power and signal cables
4
Remove the SCSI device from the device bay.
5
Remove the rails from the SCSI device and attach them to the device bay spacer.
Maintenance overview
Maintenance overview
90
SCSI devices
on page
on page 50.
Advertisement
Table of Contents
