System Board Jumpers; Removing The Cover - IBM eServer 130 xSeries User Reference Manual

System board jumpers

The following illustration identifies the jumpers on the system board.
Figure 14. Viewing the system board connectors

Removing the cover

Complete the following steps to remove the appliance server cover:
Note: If you are installing only a SCSI hard disk drive in a model 8654, you do not
1. Review the information in "Safety" on page vii.
2. Turn off the appliance server and all attached devices and disconnect all external
3. If your appliance server is installed in a rack cabinet, remove the appliance server
4. Remove the two screws from the rear of the appliance server.
5. Pull out on the cover-release lever at the back of the appliance server to release
6. Slide the cover back, then up and off the appliance server.
56
IBM xSeries 130: User's Reference
need to remove the cover.
cables and power cords.
from the rack cabinet.
the cover.