Function Specifications - Hyundai AIR 953 Instruction Manual

AUTO-ON TIMER OPERATION
1) Press button TIMER when the air conditioner is off to initiate the AUTO-ON TIMER function.
Meanwhile,
2) Before 10 hours, every press of button
by 0.5 hour; after 10 hours, every press of button
AUTO-ON time by 1 hour. You can refer to the following:
0.5 1 1.5
3) The unit will now " start " automatically at the specified AUTO-ON time when you see
not flash on the display. Meanwhile, the set temperature will revert back to
be displayed. To view AUTO-ON time, press button TIMER.
AUTO-ON/OFF TIMER OPERATION CANCEL
To cancel AUTO-ON/OFF timer operation, press button TIMER twice continuously until
disappears on the remote controller display.

FUNCTION SPECIFICATIONS

1. AUTO mode
In this mode, the air conditioner can automatically adjust the room temperature to decide the
most suitable temperature. At the start of operation, the air conditioner will automatically select
the operation mode according to the room temperature. The following table shows the conditi-
ons which are set at start up.
2. COOL mode
Press MANUAL SWING button or SWING button to change left/right swinging of air delivery.
Press FAN SPEED button to change the fan speed.
Press TEMPERATURE ADJUSTMENT button to change the set temperature.
When the room temperature is higher than the set temperature, the compressor starts; when the
room temperature is lower than the set temperature, the compressor stops.
3. DRy mode
In this mode, the air conditioner automatically sets the room temperature. TEMPERATURE
ADJUSTMENT button and FAN SPEED button are not functional. Press MANUAL SWING but-
ton or SWING button to change left/right swinging of air delivery. Dry operation is not available
when the room temperature is lower than 13 .
4. FAN mode
In this mode, the compressor doesn't operate. The unit fan alone operates.
Press MANUAL SWING button or SWING button to change left/right swinging of air delivery.
Press FAN SPEED button to change the fan speed.
5. SLEEP mode
In this mode, all the LED gets dim and the fan runs at low speed.
Press of FAN SPEED button can quit SLEEP mode.
At cool mode, after one hour of operation the set temperature will increase by 1 . One hour later,
the set temperature will increase by 1 once more. The unit will then continue operating at 2 abo-
ve the set temperature.
starts to flash on the display.
 2.5  3.5 ... 9.5
or increases or decreases the AUTO-ON time
or increases or decreases the
10 11... 24
ENG - 46
0 0.5...