IBM eServer 240 xSeries User Reference Manual page 88

To replace a drive in a hot-swap bay:
1. If your server is a tower model, unlock and open the server door.
2. Remove the defective hard disk drive 3 by placing the handle 6
3. Remove the four screws 4 that attach the drive 3 to the hot-swap tray 5 ,
4. Place the new hard disk drive on the hot-swap tray and, being careful not to
5. Install the hard disk drive in the hot-swap bay:
6. Check the hard disk drive status indicators to verify that the hard disk drive is
7. If your server is a tower model, close and lock the server door.
78
IBM xSeries User's Reference
Attention: To maintain proper system cooling, do not operate the server for
more than two minutes without either a drive or a filler panel installed in each
bay.
drive to the open position (perpendicular to the drive) and pulling the hot-swap
tray from the bay.
and remove the drive from the tray.
over-tighten the screws, attach the drive to the tray using four screws.
a. Ensure the tray handle is open (that is, perpendicular to the drive).
b. Align the drive/tray assembly so that it engages the guide rails in the bay.
c. Push the drive assembly into the bay until the drive connects to the
backplane.
d. Push the tray handle to the right until it locks.
installed properly. See "Identifying problems using status LEDs" on page 151
for details.
on the