IBM eServer 240 xSeries User Reference Manual page 150

PCNTND-23 WARNING: PCNET IRQ found = xx
Explanation: The interrupt request (IRQ) setting (xx) in the PROTOCOL.INI file does not match the
hardware IRQ setting.
Action: Remove the IRQ setting from the PROTOCOL.INI file or change the IRQ setting in the
PROTOCOL.INI file to match the IRQ setting shown in the PCI Slot/Device Information selection of the
Advanced Setup menu in the Configuration/Setup Utility program. (See "PCI Slot/Device Information" on
page 28.)
PCNTND-24 WARNING: PCNET IRQ does not match PROTOCOL.INI.
Explanation: The interrupt request (IRQ) setting in the PROTOCOL.INI file does not match the
hardware IRQ setting.
Action: Remove the IRQ setting from the PROTOCOL.INI file or change the IRQ setting in the
PROTOCOL.INI file to match the IRQ setting shown in the PCI Slot/Device Information selection of the
Advanced Setup menu in the Configuration/Setup Utility program. (See "PCI Slot/Device Information" on
page 28.)
PCNTND-25 PCI scan specified, PCI bus not found!
Explanation: The device driver cannot locate the PCI bus.
Action: Run the diagnostic programs (see "Diagnostic programs" on page 110).
PCNTND-29 WARNING: DMA number is not necessary for PCI device.
Explanation: The Ethernet controller does not require a DMA setting.
Action: Remove the DMA setting in the PROTOCOL.INI file.
PCNTND-33 PCNET device with specified IOBASE is already in use.
Explanation: The specified I/O address number is already in use by another Ethernet controller or
device.
Action: Remove the I/O address setting in the PROTOCOL.INI file.
NDIS 4.0 (Windows NT) device driver messages
This section contains the error messages for the NDIS 4.0 device drivers. The
explanation and recommended action are included with each message.
PermaNet(tm) Server: No Secondary Adapter Found. Grouping Mode is disabled.
Explanation: The failover option requires an adapter that is compatible with the device driver of the
Ethernet controller on the system board. No such adapter was found.
Action: Make sure the correct adapter is installed.
PermaNet(tm) Server: Problem Occurs on the Primary Adapter. Switching over to the Secondary
Explanation: The system detected a problem with the primary Ethernet connection and has transferred
all network traffic to the secondary Ethernet controller.
Action: Identify the cause of the failure on the primary Ethernet connection. Restoring the operational
state of the primary connection will cause the network traffic to automatically transfer to the primary
Ethernet controller.
PermaNet(tm) Server: Switching back to Primary Adapter.
Explanation: The primary Ethernet connection is now operating correctly. Network traffic will
automatically transfer to the primary Ethernet controller.
Action: None needed, message is for information only.
140
IBM xSeries User's Reference
Adapter.