IBM eServer 240 xSeries User Reference Manual page 81

Installing a non-hot-swap drive
Note: The EMI integrity and cooling of the server are both protected by having the
Refer to the following illustration of the tower model while you perform the steps in
this procedure.
Before you begin:
Read "Electrical safety" on page 42 and "Handling static-sensitive devices"
on page 44.
Read the documentation that comes with your drive.
Prepare the drive for installation (see "Preinstallation steps (all bays)" on
page 70).
non-hot-swap bays covered or occupied. When you install a drive, save the
filler panel from the bay, in case you later remove the drive and do not
replace it with another.
1
Digital linear tape (DLT) drive
2
Filler panel
3
Blue slide rails
4
Metal slide rails
Chapter 4. Installing options
71