IBM eServer 240 xSeries User Reference Manual page 68

Note: For some server models, the SCSI cable extender differs slightly from what
To install a hot-plug PCI adapter:
1. Remove the cover. See "Removing the left-side cover (tower model)" on
2. Determine which PCI adapter expansion slot you will use for the adapter.
3. Disable the selected PCI slot from your operating system. (Refer to the
4. Remove the expansion-slot cover 1 :
58
IBM xSeries User's Reference
1
Expansion-slot cover
2
Tab
3
Adapter retention latch
4
Adapter retention flap
5
Plastic divider
6
Power light
7
Attention light
8
Adapter
9
SCSI cable extender
is shown in the preceding illustration. In these models the retaining bracket
holding the cable connector has been removed.
page 48 or "Removing the cover (rack model)" on page 49.
Note: You can use only PCI slots 3–5 hot-plug PCI adapters.
documentation that comes with your operating system for information about
disabling a hot-plug PCI slot.) Disabling the PCI slot turns off the Power light
for that PCI slot.
Attention: Make sure the Power light 6 for the hot-plug PCI slot is off before
you continue to the next step.
a. Rotate the adapter retention latch 3 counterclockwise.