Ricoh MP 2001L Operating Instructions Manual page 2

Introduction
This manual contains detailed instructions and notes on the operation and use of this machine. For your safety and
benefit, read this manual carefully before using the machine. Keep this manual in a handy place for quick
reference.
Important
Contents of this manual are subject to change without prior notice.
To the maximum extent permitted by applicable laws, in no event will the manufacturer be liable for any damages
whatsoever arising out of failures of this machine, losses of the registered data, or the use of this product and
operation manuals provided with it.
Make sure that you always copy or have backups of the data registered in this machine. Documents or data might
be erased due to your operational errors or malfunctions of the machine.
In no event will the manufacturer be responsible for any documents created by you using this machine or any
results from the data executed by you.
Notes
Some illustrations in this manual might be slightly different from the machine.
Certain options might not be available in some countries. For details, please contact your local dealer.
Laser Safety:
This machine complies with the requirements of IEC60825-1:2007 for class 1 laser product. This machine contains
one AlGaInP laser diode, 9 milliwatts, 648-663 nanometer wavelength. The beam divergence angle is 28 degrees
(minimum) and 35 degrees (maximum) in the vertical direction, and 7 degrees (minimum) and 10 degrees
(maximum) in the horizontal direction, and laser beams are generated in Continuous Wave (CW) mode.
The following label is attached on the rear side of the machine:
Caution:
Use of controls or adjustments or performance of procedures other than those specified in this manual might result
in hazardous radiation exposure.
Notes:
The model names of the machines do not appear in the following pages. Check the type of your machine before
reading this manual. (For details, see page 4 "Machine Types".)
. Type 1: MP 2001L
. Type 2: MP 2501L
Certain types might not be available in some countries. For details, please contact your local dealer.
Two kinds of size notation are employed in this manual. With this machine refer to the metric version.
For good output quality, the manufacturer recommends that you use genuine toner from the manufacturer.
The manufacturer shall not be responsible for any damage or expense that might result from the use of parts other
than genuine parts from the manufacturer with your office products.
Power Source
220 - 240V, 50/60Hz, 8A
Please be sure to connect the power cord to a power source as above. For details about power source, see "Power
Connection" in Copy Reference.