Fiat Punto Owner's Handbook Manual page 25

DISPLAY FUNCTIONS
Speed limit (Speed Beep)
This function is used to set the car speed
limit (km/h or mph); the driver is imme-
diately alerted when this limit is ex-
ceeded (see section "Warning lights and
messages").
To set the desired speed limit, proceed as
follows:
– briefly press MENU ESC – the display
will show the wording (Speed Buzz);
– press + or – to select speed limit acti-
vation (On) or deactivation (Off);
– if the function is on, press + or – to se-
lect the required speed limit and then
press MENU ESC to confirm;
NB The speed may be set in the range from
30 to 200 km/h, or from 20 to 125 mph ac-
cording to the previously chosen unit (see
"Setting the distance unit (Unit)" described
below). The setting will increase/decrease
by five units each time +/– is pressed. Hold
down +/– to increase/decrease the setting
rapidly. Complete the setting with single
presses of the button when the required
setting is approached.
24
– briefly press MENU ESC to return to
the menu screen or hold the button down
to return to the standard screen without
saving.
To cancel the setting, proceed as follows:
– briefly press MENU ESC: (On) will
flash on the display;
– press –: (Off) will flash on the display;
– briefly press MENU ESC to return to
the menu screen or hold the button down
to return to the standard screen without
saving.
Trip B activation (tripB data)
This function may be used to activate
(On) or deactivate (Off) the Trip B display
(partial trip).
For more information see the "Trip com-
puter" section.
For activation/deactivation, proceed as fol-
lows:
– briefly press MENU ESC – On or Off
will flash on the display (depending on pre-
vious setting);
– press + or – to make your choice;
– briefly press MENU ESC to return to
the menu screen or hold the button down
to return to the standard screen without
saving.
Setting the clock (Set time)
This function allows you to set the clock
through two submenus: "Time" and
"Mode".
To carry out the adjustment, proceed as
follows:
– briefly press MENU ESC – the display
will show the two sub-menus "Time" and
"Mode";
– press + or – to switch between the two
sub-menus;
– select the required option and then
press MENU ESC briefly;
– if selecting "Time", briefly press MENU
ESC – the "hours" will flash on the display;
– press + or – to set the value;
– briefly press MENU ESC – the "min-
utes" will flash on the display;