Fiat Punto Owner's Handbook Manual page 142

Versions with steel rims
Proceed as follows:
❒ make sure the contact surfaces be-
tween standard wheel and hub are
clean so that the fastening bolts will not
come loose;
❒ fit the standard wheel by inserting the
first bolt two threads into the hole clos-
est to the inflation valve;
❒ fit the hub cap by aligning the crescent
hole with the bolt you have fitted, then
insert the other 3 bolts;
❒ using the wrench provided, tighten the
fastening bolts;
❒ lower the car and remove the jack;
❒ using the wrench provided, fully tight-
en the bolts in the sequence shown
previously.
Versions with alloy rims
Proceed as follows:
❒ place the wheel onto the hub and tight-
en the bolts using the wrench provided;
❒ lower the car and remove the jack;
❒ using the wrench provided, fully tight-
en the bolts in the sequence shown
previously.
When you have finished
❒ stow the spare wheel in the space pro-
vided in the boot;
❒ put the jack back in its container C-fig.
2 partially open by forcing it slightly
against the container walls to prevent
it from rattling around when travelling;
❒ put the tools back into their places in
the container;
❒ stow the container C-fig. 2, complete
with tools, inside the spare wheel;
❒ tighten the tool container clamping de-
vice A-fig. 2;
❒ refit the boot carpet or the Cargo box
(for versions/markets, where provid-
ed).
141